“We were reaching on starboard tack at a speed of 20 knots, explains Ericsson skipper Neal McDonald. The boat was fully loaded, but these were normal sailing conditions. At 12:45 GMT, we suddenly heard a loud “bang”. We immediately stopped the boat and took the mainsail down to investigate the problem. There was no visible damage, but it was obvious that the keel was flopping from side to side! After a few minutes of work, Richard Mason managed to lock the keel in one safe position. We are now sailing towards Cape Town in a much reduced capacity.”

Instead of using water ballast, as in previous constructions, the Volvo Open 70 yachts’ keel can be angled 40 degrees into the wind, counterbalancing the yachts’ heeling angle much more effectively than traditional keels, which means that more sail can be hoisted, meaning greater speed, which in turn means greater loads on the entire system.

Swing keels are not new, but it is the first time that the system has been used on such extreme yachts as the VO 70s under such extreme conditions. The swing keel is governed by two hydraulic cylinders, that push and pull respectively, and is fixed inside the cylinders by a fork that transverses the keel’s head where a hole for each mount has been drilled and fixed with a pin. The cylinder is then fixed to the hull with an articulated mount. The safety regulations state that the yacht must be able to continue sailing even if one of the cylinders is malfunctioning. The keel is 4.5 metres long with a lead bulb on the end. The distance from the pivot point to the hydraulic cylinders is around 50 cm. This means that the upper short arm needs to have ten times as much load-bearing capacity as the lower arm.

The details of the reasons of Ericsson’s keel problems are not known yet. The system will be thoroughly investigated once the boat arrives in Cape Town. As one crew member summarises: “We are in no danger. But we are very annoyed because we have lost the opportunity to sail the boat properly. ”

Source: Media Pro Intl